Q: Are the cutting wheels exposed when not in use?
No, the cutting wheels retract into the gauge faces for storage, though the rod itself has a sharp cutter on each end and should still be handled with care.
15N0201 - Pocket Marking Gauge
When we purchased an unusual double-ended marking gauge for our antique tool collection, we immediately saw an opportunity to reinterpret this useful and elegant design. Since it retains two separate measurements at once (up to 3 1/4" combined), you can alternate between them as you work without having to reset the stops. It is particularly convenient for transferring and marking repetitive dimensions such as those needed for mortises and tenons.
A thumbscrew with a brass shoe locks each of the 3/4" diameter heads in position. The single-sided bevel pulls the gauge against stock to maintain accuracy while marking – the cutting edge is at the very end of the rod (also useful for transferring depth measurements). The wheel cutters at each end slice rather than tear fibers, scribing cleanly at any point of their circumference, even on cross grain. The 4 1/2" marking gauge fits easily in an apron pocket, and the cutting wheels retract into the gauge faces for safe storage.
Made of stainless steel with hardened steel cutters and brass locking shoes. A fast, accurate direct-transfer tool.
Made in Canada.
No, the cutting wheels retract into the gauge faces for storage, though the rod itself has a sharp cutter on each end and should still be handled with care.
Set the wheel cutter's projection to match the depth of the hinge leaf, then use that same setting to scribe the corresponding mortise width.
This is more likely in coarse woods such as oak; if the wheel starts grain-following, run the gauge in the opposite direction to get a clean line.
Yes, remove the securing screw and the wheel, then lap the face of the wheel cutter on a sharpening stone.
The pocket marking gauge holds two separate measurements at once, up to 3 1/4" combined, so you can alternate between them without resetting either stop.
| Materials | Stainless steel; hardened steel cutters; brass locking shoes |
| Dimensions | 4 1/2" overall length; 3/4" dia. heads; up to 3 1/4" combined measurement capacity |
| Includes | Marking gauge |
| Package Quantity | 1 item |
| Country of Origin | Canada |
| Safety | Rod has a sharp cutter on both ends; handle with care. |
| Warranty | Lee Valley Satisfaction Guarantee |
Options:
Variations:
Pocket Marking Gauge
When we purchased an unusual double-ended marking gauge for our antique tool collection, we immediately saw an opportunity to reinterpret this useful and elegant design. Since it retains two separate measurements at once (up to 3 1/4" combined), you can alternate between them as you work without having to reset the stops. It is particularly convenient for transferring and marking repetitive dimensions such as those needed for mortises and tenons.
A thumbscrew with a brass shoe locks each of the 3/4" diameter heads in position. The single-sided bevel pulls the gauge against stock to maintain accuracy while marking – the cutting edge is at the very end of the rod (also useful for transferring depth measurements). The wheel cutters at each end slice rather than tear fibers, scribing cleanly at any point of their circumference, even on cross grain. The 4 1/2" marking gauge fits easily in an apron pocket, and the cutting wheels retract into the gauge faces for safe storage.
Made of stainless steel with hardened steel cutters and brass locking shoes. A fast, accurate direct-transfer tool.
Made in Canada.
Choose an option to view item availability.
Choose an option to view item availability.
Choose an option to view item availability.
