Festool Single-Flute Round-Over Router Bits

Order now for shipment starting June 17, 2026

These round-over bits are ideal for clean, precise edge profiling on small and delicate workpieces. Designed primarily for solid wood, they also deliver smooth results on plastic edge banding. Their collet-free, hollow-shaft design mounts straight onto the trim router shaft – no collet required – for stable, wobble-free cutting. The result is a smooth, uniform round-over and a clean finish with minimal set-up and maximum control.

Features

• Low installation height: Flush-mounted ball bearing allows routing in rabbets or across stacked panels
• Cutter radius is precisely matched to the ball bearing for accurate profiling
• Designed specifically for clean, consistent edge rounding
• Single-flute cutter reduces heat build-up to help prevent burn marks, especially when routing across the grain
• The radius transitions into a 5° relief angle for smoother exits and reduced surface marking

Areas of Application

• For rounding over plastic or solid wood edge banding
• For rounding over solid wood

To order replacement parts for Festool products, please contact our customer service department.

Designed in Germany.