Accessibility Statement


Installing crown molding is tricky even with a helper, but this hanger greatly simplifies the process so you can do it alone. It supports the molding, leaving your hands free to mark its length, position the miter, and nail it in.

Simply cut the crown to length and place it on the hanger, which hooks on a screw or nail driven near the top of the wall and can be used with any width of molding. Once tightened, it holds the molding securely for tacking in position. The low-profile hanger slips out easily before permanent fastening.

Made from ABS, the bracket is angled for 45° crown but will also accept 38° or 52° molding. Two hangers support up to 12' of crown.

A simple solution to a troublesome task.

Made in Canada.