Quantity:
This auxiliary table and fence greatly expand the capabilities of your drill press, improving accuracy, speeding production work, and increasing safety.
Mounted to the machine table with the included hardware, the 12" × 23 3/4" × 1" laminate-covered MDF table provides a smooth, stable work surface, with T-slot tracks for securing the fence and work clamps. The 2 1/2" × 3" table opening has an insert that supports through drilling and removes for use with a sanding drum, letting the bottom of the drum lie below the table surface for full workpiece contact.
The 26" long aluminum split fence opens to reveal a 2 1/2" dust port for chip clearance, and has a movable work stop for repeat positioning. At 2 3/4" high, it is tall enough to support work being drilled on edge. A telescoping extension lets you set the work stop up to 33 1/2" from center and can be installed for use left or right of the chuck.
Comes with one table insert and a 1 1/2" capacity hold-down, plus wing knobs and insert nuts for mounting. Additional hold-downs and table inserts sold separately.
Compatible with most drill presses.
Options:
Variations:
Drill-Press Table & Fence
This auxiliary table and fence greatly expand the capabilities of your drill press, improving accuracy, speeding production work, and increasing safety.
Mounted to the machine table with the included hardware, the 12" × 23 3/4" × 1" laminate-covered MDF table provides a smooth, stable work surface, with T-slot tracks for securing the fence and work clamps. The 2 1/2" × 3" table opening has an insert that supports through drilling and removes for use with a sanding drum, letting the bottom of the drum lie below the table surface for full workpiece contact.
The 26" long aluminum split fence opens to reveal a 2 1/2" dust port for chip clearance, and has a movable work stop for repeat positioning. At 2 3/4" high, it is tall enough to support work being drilled on edge. A telescoping extension lets you set the work stop up to 33 1/2" from center and can be installed for use left or right of the chuck.
Comes with one table insert and a 1 1/2" capacity hold-down, plus wing knobs and insert nuts for mounting. Additional hold-downs and table inserts sold separately.
Compatible with most drill presses.
