Description
These professional-quality zero-clearance throat plates help prevent splintering and cut-off kickback. Machined from rigid 7/16" thick aluminum, they have end-slots that let you leave the guard/splitter in place. Interchangeable phenolic inserts are used to make a zero-clearance plate for any blade type (standard or thin-kerf crosscut, combination, etc.) set at any height, or to use with dado sets up to 13/16". Starter recesses in the inserts help cut the blade opening. Levelling screws set the plate and insert flush with the table; ball detents secure the plate in position.
Each comes with a phenolic insert; extra inserts sold separately.
Delta models fit Contractor, Unisaw, tilting arbor saw and other saws with a 3 3/4" × 13 3/8" opening, and have right- or left-bevelled slots for the splitter.
The Craftsman/Ridgid plate fits only 10" belt-drive saws with a 3 3/4" × 14" opening. The left-tilt General 650 plate is 3 1/2" × 13 13/16" and fits models without a riving knife. At 3 9/16" × 12 1/2", the Jet 10" right-tilt Xacta plate fits General International contractor's saws. The Powermatic 66 plate is 3 15/16" × 14 7/16". Well-made accessories that improve the safety and quality of table-saw cuts.
Made in USA.
