Quantity:
Veritas Seconds Event
One Day – Online Only – Limited Stock
About Veritas seconds: this stock of our cabinetmaker’s trimming plane (05P7401) has some minor cosmetic flaw – a scratch, a pit in the casting or tiny blemishes – but the tool is functionally perfect. Quantities of seconds are limited and expected to sell out quickly.
Commonly called a chisel plane, this 6 1/2" long by 1 3/4" wide plane has an exposed full-width blade that lets you work up to adjacent surfaces. It excels at making paring cuts in places where a chisel would be awkward or impossible to use, making short work of cleaning up corners and joints inside carcasses.
Because the blade can be set level with the sole, you can also trim plugs or small inlays flush without marring the surrounding wood. Cast from tough ductile iron, the sole and sides are accurately machined and surface ground to be flat and square, with recesses cast into the side for grip. The large angled rear knob seats comfortably in the palm.
Four set screws accurately register the blade in the body, and it has a large thumb wheel for depth adjustment. Comes with a lapped O1 steel blade hardened to Rc58-60. The 20° bevel blade coupled with the 15° bed angle yields an effective cutting angle of 35°, severing end-grain fibers cleanly and minimizing tearing. Weighs 1.2 lb.
Made in Canada.
Options:
Variations:
Veritas Cabinetmaker's Trimming Plane – Manufacturing Second
Veritas Seconds Event
One Day – Online Only – Limited Stock
About Veritas seconds: this stock of our cabinetmaker’s trimming plane (05P7401) has some minor cosmetic flaw – a scratch, a pit in the casting or tiny blemishes – but the tool is functionally perfect. Quantities of seconds are limited and expected to sell out quickly.
Commonly called a chisel plane, this 6 1/2" long by 1 3/4" wide plane has an exposed full-width blade that lets you work up to adjacent surfaces. It excels at making paring cuts in places where a chisel would be awkward or impossible to use, making short work of cleaning up corners and joints inside carcasses.
Because the blade can be set level with the sole, you can also trim plugs or small inlays flush without marring the surrounding wood. Cast from tough ductile iron, the sole and sides are accurately machined and surface ground to be flat and square, with recesses cast into the side for grip. The large angled rear knob seats comfortably in the palm.
Four set screws accurately register the blade in the body, and it has a large thumb wheel for depth adjustment. Comes with a lapped O1 steel blade hardened to Rc58-60. The 20° bevel blade coupled with the 15° bed angle yields an effective cutting angle of 35°, severing end-grain fibers cleanly and minimizing tearing. Weighs 1.2 lb.
Made in Canada.
