These featherboards are simple to set up and adjust. Made of rugged plastic composite, they are reversible for installation on either side of the cutter and can be oriented for use as a hold-down.
They have 5 1/4" of lateral adjustment relative to the cutter and lock in position using two 1 1/2" wing knobs. The single featherboard includes 3/4" table bars for use with most miter slots, plus bolts to fit a 1/4" T-track.
The double featherboard system comes with two stand-alone featherboards (each with 3/4" table bars and 1/4" T-bolts), as well as spacers and hardware to stack them for thick workpieces or those that must be supported on edge.
Each featherboard measures about 6 1/2" long, 7 1/4" wide, and 5/8" thick.
Made in USA, they are essential equipment for improving safety and workpiece control.