These kits are designed to simplify drawer construction and installation.
Each includes two tandem Blumotion slides, two metal drawer sides, and brackets for mounting the drawer back, bottom and front panels (inset or overlay) – which you make from the material of your choice, up to 15mm (5/8") thick. Built-in vertical, lateral and tilt adjustment mechanisms let you fine-tune the position of the drawer face for a precise fit.
Fully concealed by the drawer sides, the full-extension slides (rated for 75 lb) use a carriage system with nylon rollers to provide a quiet, smooth-running action, even under full load. A spring mechanism pulls the drawer closed during the last 2 1/4" of travel, and integrated Blumotion dampers (two per drawer) provide a soft-close motion, preventing it from slamming. Installed drawers can be easily decoupled from the slides for cleaning.
The type M kits have single-panel sides, forming drawers with an inside height of 68mm (2 5/8") that occupy a 98.5mm (3 7/8") high drawer space. The type D kits form drawers with an inside height of 195mm (7 11/16") that occupy a 220mm (8 5/8") high drawer space. They have sides consisting of upper and lower panels with an open section in between. This opening can be left empty to permit viewing of drawer contents from the side, or fitted with an optional insert panel made of steel or tempered glass with a frosted finish, available separately.
All models require #6 screws (not included). Sizes listed are drawer depth (front to back); for overlay drawers, required cabinet depth is 3mm greater than the overall slide length. Maximum drawer width is 1200mm (47 1/4"). Made in Austria.